Registering Input Signal Data - Panasonic PT-D9510E Operating Instructions Manual

Dlp based projector
Hide thumbs Also See for PT-D9510E:
Table of Contents

Advertisement

Registering input signal data

Because the projector has no factory pre-set data of input signals, be sure to register input signal data before
first use.
NOTE
• Up to 64 different input signals can be registered.
• Input a signal according to an input module installed on the projector and register the signal data.
Registration new signal
• If a new signal is input and MENU key of the remote control unit or projector operating panel buttons are pressed,
the new signal registration screen shown below will be displayed.
The registration procedure is given below.
Registration procedure
(Displayed contents is an
example)
42
Press the MENU button. ... The NEW SIGNAL INPUT screen will be displayed.
Press the ENTER button. ... The SIGNAL STATUS screen will be displayed.
NOTE
• Parameters such as the memory number, signal selector input number, slot input
number, type of input signal, frequency, and synchronizing signal are identified
and displayed automatically.
• The memory numbers are from A1 to H8.(Each from A to H has eight memory
numbers each.)
The lowest number of available memory numbers is displayed automatically.
If there is no available memory number, follow the overwriting procedure on the
next page.
• For the registration name (NAME), the signal name and memory number are
displayed automatically.
When using the original name displayed automatically on the screen without
change, press the ENTER button.
• The registration is complete and the display will return to the MENU screen.
When changing the original name, press LEFT(
to select a letter or number and then press the UP (
buttons to enter the selected letter or number. (If clearing the name change,
press the STD button.)
After changing the name, press the ENTER button.
• The registration of the new name is complete and the display will return to the
MENU screen.
• If the MENU button is pressed instead of the ENTER button, the original
NOTE
name will be registered instead of the new name.
) and RIGHT (
) arrow buttons
) and DOWN (
) arrow

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pt-d9610e

Table of Contents