Other Options - Panasonic KX-TCD340E Operating Instructions Manual

TCD340E(e).book Page 37 Thursday, June 9, 2005 9:50 AM
L If you changed the PIN, enter it (page
37).
4
Select "Call Options", then press
,.
5
Select "Call Restrict", then press
,.
L The base unit extension number "0"
and the extension numbers of all
registered handsets are displayed.
6
Select the extensions which will be
restricted by pressing the desired
number.
L Flashing numbers indicate call
restriction is turned on for the
corresponding extension.
L To turn call restriction off for an
extension, press the dial key
corresponding to its extension
number. The number will stop flashing.
7
Press ,.
8
Select a memory location, then press
,.
L If the memory location already
contains a restricted number, the
number is displayed.
9
Enter the phone number or area code to
be restricted (8 digits max.), then press
,.
L To erase a restricted number, press
{C/T}.
10
Press {ih}.
Turning call bar on/off
This feature prohibits making outside calls
with the base unit. When call bar is turned
on, only intercom calls and calls to
emergency numbers (page 36) can be
made. Call bar can be set independently for
the handset (page 31) and the base unit.
1
Press $ (middle soft key).
2
Select Z, then press ,.
3
Enter "0000" (default base unit PIN).
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
Base Unit Settings
L If you changed the PIN, enter it (page
37).
4
Select "Call Options", then press
,.
5
Select "Call Bar", then press ,.
6
Select "On" or "Off", then press ,.
7
Press {ih}.

Other options

Changing the base unit PIN
(Personal Identification Number)
For security, the base unit PIN must be
entered when changing certain settings. The
default PIN is "0000".
Important:
L If you change the PIN, please make note
of your new PIN. The unit will not reveal
the PIN to you. If you forget your PIN,
consult your nearest Panasonic service
centre.
1
Press $ (middle soft key).
2
Select Z, then press ,.
3
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it.
4
Select "Other Options", then press
,.
5
Select "Base Unit PIN", then press
,.
6
Enter the new 4-digit base unit PIN, then
press ,.
7
Press {ih}.
Resetting the base unit to its
default settings
1
Press $ (middle soft key).
2
Select Z, then press ,.
3
Enter "0000" (default base unit PIN).
37