Panasonic KX-TCD340E Operating Instructions Manual page 68

TCD340E(e).book Page 68 Thursday, June 9, 2005 9:50 AM
Useful Information
Telephone
Problem
I cannot make or receive calls.
The unit does not ring.
The batteries should be charging
but the battery icon does not
change.
A busy tone is heard when {C} is
pressed.
Static is heard, sound cuts in and
out. Interference from other
electrical units.
Noise is heard during a call.
68 Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
Cause & solution
L The AC adaptor or telephone line cord is not
connected. Check the connections.
L If you are using a splitter to connect the unit,
remove the splitter and connect the unit to the wall
socket directly. If the unit operates properly, check
the splitter.
L Disconnect the base unit from the telephone line
and connect the line to a known working telephone.
If the working telephone operates properly, contact
our service personnel to have the unit repaired. If
the working telephone does not operate properly,
contact your service provider.
L The call bar feature is turned on. Turn it off (page
31, 37).
L You dialled a call restricted number (page 36).
L The key lock feature is turned on. Turn it off (page
17).
L The ringer volume is turned off. Adjust the handset
ringer volume (page 28) and the base unit ringer
volume (page 20).
L The night mode feature is turned on. Turn it off
(page 29, 35).
L Clean the charge contact and charge again (page
13).
L The AC adaptor is disconnected. Plug in the AC
adaptor.
L The handset is too far from the base unit. Move
closer and try again.
L Another handset or the base unit is on an outside
call. Wait for the other user to complete the call.
L Locate the handset and the base unit away from
other electrical appliances.
L Move closer to the base unit.
L Your unit is connected to a telephone line with DSL
service. We recommend connecting a filter (contact
your DSL service provider) to the telephone line
between the base unit and the telephone line jack.
L You are using the handset or base unit in an area
with high electrical interference. Locate the handset
and base unit away from interference sources, such
as antenna and mobile phones.