Finisher - Konica Minolta BIZHUB C450P User Manual

8
Symptom
Printing is not possible
even though the pass-
word is entered on a ma-
chine with user
authentication/account
track set.

Finisher

Symptom
The finisher cannot be
used.
The pages cannot be
stapled.
The pages that were fed
out were not uniformly
loaded and the punched
holes or staples are in-
correctly positioned.
Even though a Punch
setting was selected,
holes are not punched.
(when punch kit is in-
stalled on FS-603 or FS-
507)
If any message other than those listed above appears, perform the operation
described in the message.
If the problem is not corrected after the described operation is performed,
contact your technical representative.
8-38
Possible Cause
Did the message "Your ac-
count has reached its maxi-
mum color-print (black-print)
allowance." appear?
Possible Cause
Is no power supplied to the
connector?
Have the staples run out?
Is the paper curled?
Is there a gap between the
lateral guides in the paper
tray and the side of the pa-
per?
Did the message "Punch
Scrap Full." appear?
Troubleshooting
Remedy
Contact your administrator.
Remedy
Check that the cord is correctly in-
serted into the connector.
Replace the staple cartridge. (See
p. 6-8.)
Remove the paper from the paper
tray, turn it over, and then load it
again.
Slide the lateral guides in the paper
tray against the side of the paper so
that there is no gap.
Empty the hole-punch waste con-
tainer.
C450P