Table of Contents
Advertisement
1
Getting Started
About This Manual
This User's Guide provides installation and programming instructions for the
3800g. Product specifications, dimensions, warranty, and customer support
information are also included.
Hand Held Products bar code imagers are factory programmed for the most
common terminal and communications settings. If you need to change these
settings, programming is accomplished by scanning the bar codes in this guide.
An asterisk (*) next to an option indicates the default setting.
Unpacking the Imager
After you open the shipping carton containing the 3800g, take the following
steps:
• Check to make sure everything you ordered is present.
• Save the shipping container for later storage or shipping.
• Check for damage during shipment. Report damage immediately to the
carrier who delivered the carton.
3800g Models
Note: The Hand Held Products 3800g imager may be used with many
interfaces, which are described in this User's Guide. Refer to the chart
below to determine the models that can be used with your interface.
Refer to
Interfaces.
The chart below lists the 3800g imager models.
Models
3800G04E,
3800G14E
3800G05E,
3800G15E
3800g User's Guide
Chapter 6
for programming information regarding Secondary
Primary Interfaces
TTL level RS-232, USB, Key-
board wedge
TTL level RS-232, IBM Retail,
USB, Retail USB, Keyboard
wedge
Secondary
Interfaces
TTL level RS-232
TTL level RS-232
1 - 1
Advertisement
Table of Contents
