Hands Free Time-Out; Reread Delay; Trigger Modes - Hand Held Products HANDHELD 3800G User Manual

Hands Free Time-Out

The Automatic Trigger and Presentation Modes are referred to as "hands free"
modes. If the imager's trigger is pulled when using a hands free mode, the
imager changes to manual trigger mode. You can set the time the imager should
remain in manual trigger mode by setting the Hands Free Time-Out. Once the
time-out value is reached, (if there have been no further trigger pulls) the imager
reverts to the original hands free mode.
Scan the Hands Free Time-Out bar code, then scan the time-out duration (from
0-300,000 milliseconds) from the inside back cover, and Save . Default = 5,000
ms.

Reread Delay

This sets the time period before the imager can read the same bar code a second
time. Setting a reread delay protects against accidental rereads of the same bar
code. Longer delays are effective in minimizing accidental rereads at POS (point
of sale). Use shorter delays in applications where repetitive bar code scanning
is required. Default = Medium.
Reread Delay only works when in automatic trigger mode or presentation mode
(see page 3-4).
Short (500 ms)
Long (1000 ms)
3800g User's Guide
Hands Free Time-Out
* Medium (750 ms)
Extra Long (2000 ms)
3 - 5