Installation Of The Dc Sparker - FPI U32 Owners & Installation Manual

INSTALLATION
9) Reinstall new burner orifi ce LPG
stamped #52 and tighten.
10) Turn control knob to the "OFF" position.
11) Remove the black
protection cap by hand
from the hi-low knob
(Fig.1).
Fig. 1
12) Insert a 5/32" or 4mm
Allen wrench into the
hexagonal key-way
of the screw (Fig.
2), rotate it counter-
clockwise until it is free
and extract it.
Fig.2
13) Check that the screw is clean and if
necessary remove dirt.
14) Flip the screw (Fig. 3).
15) Using the Allen wrench
as shown in Fig.4, rotate
the screw clockwise until
snug, do not overtighten.
WARNING!
Do not over tighten the screw.
Recommended to
grip the wrench by the short side.
18
16) Verify that if the conversion is from
NG to LPG, the screw must be re-
assembled with the red o-ring visible
(Fig. 5).
Red o-ring visible
Fig.5
17) Re-assemble the black protection
cap (Fig. 6).
18) Reverse steps 6 - 1.
For U32-5 Only:
18a) Install the air defl ector to the back wall of
the fi rebox using 2 screws.
Fig.3
Air Defl ector
Also check that the pilot and main
Fig.4
burner injectors are appropriate for
19) Attach the label "This unit has been
converted to LPG" near or on top of the
serial # decal.
20) Replace yellow "NG" label with red
"LPG" label.
LPG Configuration
Fig. 6
WARNING!
the gas type.

Installation of the DC Sparker:

21) Locate the Piezo Ignitor situated at the
side of valve.
22) Remove the Piezo Ignitor by unscrewing
the nut at the back of the mounting
bracket.
Ignitor
Wire
Piezo
Ignitor
23) Disconnect the ignitor wire from the
Piezo Ignitor and connect it to the DC
Sparker.
DC
Sparker
Ignitor
Wire
24) Connect the DC spark generator wires
to the SIT Valve with the screw, which is
provided in the kit.
U32-5 FPI Direct Vent Gas Insert
Piezo
Ignitor