Table of Contents
Advertisement
EASY ASSEMBLY
Assembly is easy and requires no tools.
G
1
Position detector upright.
G
2
Rotate
COLLAR fully in a counter
clockwise direction.
G
3
Insert your finger inside the
tube and make sure the
INTERNAL CAM LOCK is
flush with the inside of the
tube.
G
4
Insert the LOWER STEM into
the S-ROD.
G
5
Rotate the LOWER STEM until the SILVER BUTTON locates in the hole.
G
6
Twist the LOCKING COLLAR fully in the clockwise direction until it locks.
G
7
If your detector has 3 tubes and 2 locking collars, repeat this process
on the Middle Stem.
G
8
Position the Lower Stem (the straight tube) with the Silver Button
toward the back.
Searchcoil to the plastic extension protruding from the Lower Stem.
G
9
Press the button on the upper end of the Lower Stem, and slide the
Lower Stem into the S-Rod.
Adjust the Stem to a length that lets
you maintain a comfortable upright
posture, with your arm relaxed at
your side, and the Searchcoil parallel
to the ground in front of you.
G
1 0
Wind the Cable securely around the
Stem.
G
1 1
Insert the Plug into the matching
Connector on the right underside of
the Detector Body. Be sure that the
key-way and pins line up correctly.
Caution:
Do not force the plug in. Excess
force will cause damage.
To disconnect the cable, pull on
the plug.
Do not pull on the cable.
the
LOCKING
Using the Bolt and Knurled Knob, attach the
S-ROD
S-ROD
Connector
on back of
unit Body
Connector
LOCKING
COLLAR
INTERNAL
CAM LOCK
SILVER BUTTON
MIDDLE
STEM
MIDDLE STEM
Plug
Detector
Body
S-Rod
3
Advertisement
Table of Contents
