Easy Assembly - Bounty Hunter Tracker IV Owner's Manual

EASY ASSEMBLY

Assembling your Tracker IV Metal
Detector is easy and requires no
tools. Just follow these steps:
G
1 Using the supplied bolt and
knurled knob, attach the search
coil to the lower stem.
G
2 Press the button on the upper
end of the lower stem and slide
the lower stem into the upper
stem.
Adjust the stem to a length that lets you
maintain a comfortable upright posture,
with your arm relaxed at your side.
G
3 Wind the search coil cable
around the stem. Leave enough
slack in the cable to let you adjust
the coil when you are hunting on
uneven ground. Then tighten the
knob at the end of the search
coil.
Note: To adjust the coil,
simply loosen the knob.
G
4 Insert the coil's plug into the
matching connector on the control
housing. Be sure the holes and
pins line up correctly.
Caution:
• Do not force the plug in.
Excess force will cause damage.
• To disconnect the cable, pull out
the plug. Do not pull on the cable.
Bolt
Bottom view
Lower
Stem
Search
Coil
Cable
Upper
Stem
Knurled
Knob
Search Coil
Lower
Stem
Upper
Stem
Bottom side
Plug
Control
Housing
Connector
on back of
control housing
3