Easy Assembly - Bounty Hunter Fast Tracker Owner's Manual

EASY ASSEMBLY

Assembling your Fast Tracker Metal
Detector is easy and requires no
tools. Just follow these steps:
G
1 Using the supplied bolt and
knurled knob, attach the
search coil to the lower stem.
G
2 Press the button on the upper end
of the lower stem and slide the
lower stem into the upper stem.
Adjust the stem to a length
that lets you maintain a com-
fortable upright posture, with
your arm relaxed at your
side. Maintain the search coil
about 1 inch above the
ground as you sweep.
G
3 Wind the search coil cable
around the stem. Leave
enough slack in the cable to let
you adjust the coil when you
are hunting
ground. Then tighten the knob
at the end of the search coil.
Note: To adjust the coil,
simply loosen the knob.
G
4 Insert the coil's plug into the
matching connector on the
control housing. Be sure the
holes and pins line up correctly.
Caution:
• Do not force the plug in.
Excess force will cause damage.
• To disconnect the cable, pull
out the plug. Do not pull on
the cable.
on uneven
Search
Coil
Cable
Lower
Stem
Upper
Stem
Control
Housing
Search Coil
Bottom side
Lower
Stem
Upper
Stem
Plug
3