Easy Assembly - Bounty Hunter pioneer 101 Instruction Manual

Assembling your Pioneer 101
Metal Detector is easy and re-
quires no special tools. Just
follow these steps:
1. Using the supplied bolt and
knurled knob, attach the
search coil to the lower
stem.
2. Press the button on the up-
per end of the lower stem
and slide the lower stem
into the upper stem.
Adjust the stem to a length
that lets you maintain a com-
fortable upright posture, with
your arm relaxed at your side.
Maintain the search coil
about 1/2 inch above the
ground as you sweep.
Searchcoil
Searchcoil Cable
Lower Stem
Upper Stem
Plug
Bolt Knurled Knob

EASY ASSEMBLY

Connector
Control Housing
Upper
Stem
Button
3. Wind the search coil cable
around the stem. Leave
enough slack in the cable
to let you adjust the coil
when you are hunting on
uneven ground. Then
tighten the knob at the end
of the search coil.
Note: To adjust the coil,
simply loosen the knob.
4. Insert the coil's plug into
the matching connector on
the control housing. Be sure
the holes and pins line up
correctly.
Caution:
• Do not force the plug in.
Excess force will cause
damage.
• To disconnect the cable, pull
out the plug. Do not pull on
the cable.
3