Metal Detecting Applications; Easy Assembly; Using Headphones - Bounty Hunter Prospector Owner's Manual

METAL DETECTING APPLICATIONS

trash items. Gold rings will induce a low sound. Be aware that some
pull-tabs can also induce a low tone.
Silver will induce a high tone. Chains and necklaces are difficult to
find. If you are looking for gold rings, don't get discouraged; you
will dig up many broken pull-tabs before you find your first gold
ring!
HOUSEHOLD APPLICATIONS
Find property markers, lost keys, machine parts, and other lost
items.
CONTROL SETTINGS REQUIRED:
G
1 Toggle switch in center position.
G
2 Discriminate control knob is in OFF position.
GOLD PROSPECTING
Find gold in abandoned gold mines and river beds where gold is
continuously washed down stream from its place of origin.
CONTROL SETTINGS REQUIRED:
G
1 Toggle switch in center position.
G
2 Discriminate control knob is in OFF position.

USING HEADPHONES

Using headphones (not included) improves battery life, and prevents
the sounds from annoying bystanders.
It also allows you to hear subtle changes in the sound more clearly,
particularly if searching in a noisy location. For safety reasons, do not
use headphones near traffic or where other dangers are present. This
device is to be used with interconnecting cables/headphone cables
shorter than three meters.
14
(cont.)

EASY ASSEMBLY

Assembling your
Detector is easy and requires no
tools. Just follow these steps:
G
1
G
2
Adjust the stem to a length that lets
you maintain a comfortable upright
posture, with your arm relaxed at your
side.
G
3
G
4
Caution:
• Do not force the plug in.
• To disconnect the cable, pull out
Prospector Metal
Using the supplied bolt and
knurled knob, attach the search
coil to the lower stem.
Press the button on the upper
end of the lower stem and slide
the lower stem into the upper
stem.
Wind the search coil cable
around the stem. Leave enough
slack in the cable to let you ad-
just the coil when you are
hunting on uneven ground.
Then tighten the knob at the
end of the search coil.
Note: To adjust the coil,
simply loosen the knob.
Insert the coil's plug into the
matching connector on the con-
trol housing. Be sure the holes
and pins line up correctly.
Excess force will cause damage.
the plug. Do not pull on the cable.
Connector
on back of
control housing
Bottom view
Lower
Stem
Upper
Stem
3