Easy Assembly - Bounty Hunter THE COMMANDO Owner's Manual

EASY ASSEMBLY

Assembly is easy and requires no tools.
1
Position detector upright.
2
Rotate the LOCKING
COLLAR fully in a counter
clockwise direction.
3
Insert your finger inside the
tube and make sure the
INTERNAL CAM LOCK is
flush with the inside of the
tube.
4
Insert the LOWER STEM into
the S-ROD.
5
Rotate the LOWER STEM until the SILVER BUTTON locates in the hole.
6
Twist the LOCKING COLLAR fully in the clockwise direction until it locks.
7
If your detector has 3 tubes and 2 LOCKING COLLARS, repeat this
process on the MIDDLE STEM.
8
Position the LOWER STEM (the straight tube) with the SILVER
BUTTON toward the back. Using the BOLT and KNURLED KNOB,
attach the SEARCHCOIL to the plastic extension protruding from the
LOWER STEM.
9
Press the button on the upper end
of the LOWER STEM, and slide the
LOWER STEM into the S-ROD.
Adjust the STEM to a length that lets
you maintain a comfortable upright
posture, with your arm relaxed at your
side, and the SEARCHCOIL parallel to
the ground in front of you.
J
Wind the CABLE securely around the
STEM.
K
Insert the PLUG into the matching
CONNECTOR on the right underside
of the DETECTOR BODY. Be sure
that the key-way and pins line up
correctly.
Caution:
Do not force the plug in. Excess force may cause damage.
To disconnect the cable, pull on the plug.
Do not pull on the cable.
S-ROD
S-ROD
Connector on
back of unit
body
Connector
LOCKING
COLLAR
INTERNAL
CAM LOCK
SILVER BUTTON
MIDDLE
STEM
MIDDLE STEM
Plug
Detector
Body
S-Rod
3