Assembly - Bounty Hunter Tracker IV Owner's Manual

EASY ASSEMBLY
Assembling your Tracker IV Met al
De tec tor is easy and re quires no
tools. Just fol low these steps:
1 Using the supplied bolt and
knurled knob, at tach the
searchcoil to the low er stem.
2 Press the button on the up per
end of the lower stem and slide
the lower stem into the upper
stem.
Adjust the stem to a length that
lets you maintain a com fort able
upright pos ture, with your arm
relaxed at your side.
3 Wind the searchcoil ca ble
around the stem. Leave
enough slack in the cable to let
you ad just the coil when you
are hunting on uneven ground.
Then tight en the knob at the
end of the searchcoil.
Note: To adjust the coil,
simply loos en the knob.
4 Insert the coil's plug into the
match ing con nec tor on the
control hous ing. Be sure the
holes and pins line up cor rect ly.
Caution:
Do not force the plug in.
Excess force will cause dam age.
To disconnect the cable, pull out
the plug.
Do not pull on the ca ble.
4
Bolt
Searchcoil
Cable
Lower
Stem
Knurled
Knob
Searchcoil
Bottom view
Lower
Stem
Upper
Stem
Plug
Bottom side
Control
Housing
Upper
Stem
Connector
on back of
Control Housing