Pci Hot Plug; Disk Controller; Internal Hot-Plug Drive Bays; Fixed Internal Media Drive Bays - Compaq PROLIANT DL760 User Manual

PCI Hot Plug

PCI Hot Plug provides the ability to remove, replace, upgrade, and add
PCI/PCI-X expansion boards without powering down the server. Any
PCI/PCI-X board can be placed in a PCI Hot Plug slot. PCI Hot Plug device
drivers and operating system support, however, are required to enable PCI
Hot Plug.
The PCI Hot Plug button allows for PCI Hot Plug access directly at each
PCI/PCI-X slot. A PCI Hot Plug button is located above each PCI/PCI-X slot,
providing PCI Hot Plug control directly at the server without the use of the
PCI Hot Plug utility software.
For more information about PCI Hot Plug, refer to the Server
Documentation CD.

Disk Controller

The Compaq ProLiant DL760 server is provided with a Dual Channel
Integrated Smart Array Controller. One channel is dedicated to the internal
drive bay and the other channel is connected to the external SCSI connector.
See Chapter 8, "Configuring the Server," for descriptions of the features and
array setup procedures for these controllers

Internal Hot-Plug Drive Bays

The internal hot-plug drive bays support four 1-inch, Ultra3 hard drives.
Drives may be of any storage capacity, but must be mounted on Compaq
universal drive carriers (hot-plug drive trays).
Internal drives are controlled by a Dual Channel Integrated Smart Array
Controller. See Chapter 8, "Configuring the Server," for a description of the
integrated controller.

Fixed Internal Media Drive Bays

The fixed internal media drive bays support two non-hot-plug media drives:
I
1.44-MB diskette drive
I
IDE CD-ROM drive
Server Features 1-7
.