Starting The Compaq Array Configuration Utility - Compaq PROLIANT DL760 User Manual

8-6 Compaq ProLiant DL760 Servers User Guide

Starting the Compaq Array Configuration Utility

The Compaq ProLiant DL760 server is shipped with the ACU on the
SmartStart and Support Software CD. Start the utility as described in the
following procedure. If, for any reason, you can not start the utility as
described here, the utility is available in a variety of locations as described in a
section titled "Alternate Sources of the Array Configuration Utility" later in
this chapter.
1. Power off the server if necessary, then power on the server.
2. Boot the SmartStart and Support Software CD.
3. Select the Array Configuration Utility program.
When you start the ACU, the software checks the configuration of each
controller and its drive arrays. If the arrays are unconfigured or if the
configuration is less than optimal, the configuration wizard takes over to guide
you through the configuration process.
Online Help
Press the F1 key or click the Help button to activate context-sensitive help for
each screen. A status bar at the bottom of the screen also provides immediate
help messages describing the current selection.