Pci Hot Plug Interface Board - Compaq ProLiant 8000 Maintenance And Service Manual

PCI Hot Plug Interface Board

To remove the PCI Hot Plug interface board:
1. Remove the top access panel. See "Top Access Panel" earlier in this chapter.
2. Disconnect the cable securing the interface board to the system board
3. Remove the extended SCSI dividers. See "Extended SCSI Dividers" earlier in
this chapter.
4. Remove all I/O expansion boards. See "I/O Expansion Boards" earlier in this chapter.
5. Open the PCI expansion slot levers.
6. Pull the six push-pull fasteners to release the interface board
7. Pull the interface board away from the sheet metal
Figure 2-67. Removing the PCI Hot Plug interface board
Reverse steps 1 through 7 to replace the PCI Hot Plug interface board.
2
Removal and Replacement Procedures 2-73
.

.

3
1
.