Power Button/Led Assembly; Pci Hot Plug Backplane; External Cabling Configurations; Scsi Cabling Guidelines - Compaq 195294-001 - ProLiant - ML370R Setup And Installation Manual

8-10 Compaq ProLiant ML370 Generation 2 Server Setup and Installation Guide

Power Button/LED Assembly

PCI Hot Plug Backplane

External Cabling Configurations

SCSI Cabling Guidelines

Compaq ProLiant ML370 Generation 2 servers include a power button/LED
assembly that connects directly to the system board. For instructions on
replacing the power button/LED assembly, refer to the maintenance and
service guide for your server.
Compaq ProLiant ML370 Generation 2 servers include a PCI Hot Plug
backplane that provides power to the two PCI Hot plug expansion slots. The
backplane is connected to the system board with a single PCI cable.
For information about replacing the PCI Hot Plug backplane or cable, contact
a Compaq authorized service provider or refer to the maintenance and service
guide for your server.
The following sections describe cabling configurations for peripheral devices
and external storage devices supported by the ProLiant ML370 Generation 2
server.
The external VHDCI SCSI connector is located on the rear panel of the server
as shown in the following figure. This interface enables you to install and
manage external SCSI devices with the system standard Integrated Dual
Channel Ultra3 SCSI controller.
IMPORTANT: Connect either external devices to the external VHDCI SCSI connector or
internal devices to SCSI connector A. Your server does not support both internal and
external devices on the same channel at the same time.