INSTALLATION
REQUIREMENTS
Parts Supplied
Gather the required tools and parts before starting installation.
Read and follow the instructions
provided with any tools listed
here.
Tools needed
•
Pliers
•
Phillips screwdriver
•
Flat-blade screwdriver
•
3/16"and 1/4"nut drivers or
hex sockets
•
Measuring tape or ruler
•
11/2"hole saw bit
•
10" adjustable wrench
•
Utility knife
•
Level
•
Electric drill
•
1/8"drill bit
•
SecurityT-20
TORX®t
driver (if installing custom
front panels)
Check that all parts are included.
A
B
Parts needed
E
A. 60" (152.4 cm) flexible water supply line
B. Zip tie
C. 2 appropriate
sized UL listed wire connectors
D. Handle (if installing custom front panels(
E. Overlay Panel (if installing custom front panels)
D
A. _" UL listed strain relief
B. 1.25" hose clamp
C. 8 mounting bracket screws
D. 4 unit mounting screws
E. Y drain connector
F. 4 mounting brackets
G. Drain connector spring
clamps
H. 2 trim strips
I. Toe kick brackets
J. 2 toe kick bracket screws
K. Toe kick trlin
L. 2 panel fasteners (on some
models)
M. 10 TORX'_ screws (on some
models)
IMPORTANT: Observe all governing codes and ordinances.
Failure to meet codes and ordinances could lead to fire or
electrical shock.
Proper installation is your responsibility.
•
Contact a qualified installer to ensure that the dishwasher is
installed to meet all electrical and plumbing national and local
codes and ordinances.
•
Install the dishwasher as specified in these instructions.
•
Have everything you need to properly install dishwasher.
•
Protect dishwasher and water lines leading to dishwasher
against freezing. Damage from freezing is not covered by the
warranty.
•
This dishwasher
is manufactured
for indoor use only.
•
Install and level dishwasher on a floor that will hold the
weight, and in an area suitable for its size and use.
1-®TORX is a registered trademark of Textron Innovations Inc.