INSTALLATION
REQUIREMENTS
_4_9 __
_J_ _'__
Gather the required tools and parts before starting installation.
Read and follow the instructions
provided with any tools listed
here.
Tools Needed
•
Pliers
•
Phillips screwdriver
•
Flat-blade screwdriver
•
¾e" and 1¼,, n ut drivers or
hex sockets
•
Measuring tape or ruler
•
1Y2" hole saw bit
•
10" adjustable wrench
•
Utility knife
•
Level
•
Cordless drill
•
V8"drill bit
•
Security T-20 TORX®t driver
(on some models)
Pa_s Needed
A. 72" (182.9 cm) flexible water supply fine
B. Zip tie
C. Appropriate
sized UL Listed wire connectors
(2)
1-®TORX is a registered
trademark of Acument
Intellectual
Properties,
LLC
Parts Supplied
Check that all parts are included.
A. _" UL Listed/CSA Approved
strain relief
B. 1.25" hose clamp
C. Mounting bracket screws (8)
D. Unit mounting screws (4)
E. Drain hose connector
F. Mounting brackets (4)
G. Drain connector
spring clamps (2)
_G
N
H. Trim strips (2)
I. Toe kick brackets (2)
J. Toe kick bracket screws (2)
K. Toe kick trim
L. Panel fasteners (on some
models) (2)
M. TORX®t screws (on some
models) (10)
N. Drain hose