Selecting The Wash Programme; Starting The Wash Cycle - Hoover Nextra HNF6137 Instruction Book

40001406Eng.qxd 31/08/2004 11:20 Page 29

Selecting the wash programme

Refer to the Programme Guide or the programme
descriptions on the front of the machine to select
the most suitable programme.
The programme is selected by turning the
programme selector and aligning the programme
name with the indicator.
Check that the STOP indicator is flashing, if not
check that the door is properly closed.
Check that the tap is turned on and that the
discharge hose is positioned correctly.
Select the required wash options

Starting the wash cycle

Press the Avvio Pausa button. The Blocco Porta
indicator and the START light illuminate, within a
few seconds the programme will begin.
Do not try to open the door when the Blocco
Porta indicator is on.
Do not open the dispenser drawer during the
wash programme.
If you wish to pause the programme press the
Avvio Pausa button and after 2 minutes the door
can be opened. To cancel the programme the
programme selector should be turned to the OFF
position. A new programme can be selected after
cancelling the programme.
When the programme has finished
Wait for the door lock to be released. The Blocco
Porta indicator will go out after approximately 2
minutes and then the door can be opened.
Switch off the machine by turning the
programme selector to the OFF position before
selecting the next programme (this action resets
the memory in the machine).
Open the door.
Remove the laundry.
Disconnect the plug from the mains power supply
and turn off the water supply after every use.
29