Selecting The Wash Programme; Starting The Wash Cycle - Hoover HNL 642 Instruction Book

40005508.qxd 05/03/2008 09:51 Page 24

Selecting the wash programme

Refer to the Programme Guide or the programme descriptions
on the front of the machine to select the most suitable
programme.
The programme is selected by turning the programme selector
and aligning the programme name with the indicator.
Check that the STOP indicator is flashing, if not check that the
door is properly closed.
Check that the tap is turned on and that the discharge hose is
positioned correctly.
Select the required wash options

Starting the wash cycle

Press the Start Pause button. The door locked indicator and
the START light illuminate and then after a few seconds the
programme will begin.
Do not try to open the door when the door locked indicator is
on.
Do not open the dispenser drawer during the wash
programme.
If you wish to pause the programme press the Start Pause
button; after two minutes you will be able to open the door.
To cancel the programme the programme selector should be
turned to the OFF position. A new programme can be selected
after cancelling the previous programme.
When the programme has finished
Wait approximately two minutes for the door lock to be
released. When the door locked indicator light goes it will
then be safe to open the door.
Switch off the machine by turning the programme selector to
the OFF position so that it will be ready the next time you use
the machine (this action resets the memory in the machine).
Open the door.
Remove the laundry.
Disconnect the plug from the mains power supply and turn off
the water supply whenever you finish using it.
24