The Control Panel - Hoover HNL 642 Instruction Book

40005508.qxd 05/03/2008

The Control Panel

Countdown Display
START
PAUSE
The programme
selector must be return
to the OFF position to
reset the controls
between each wash
cycle.
To start another wash
cycle the programme
selector must be
returned to OFF once
again before the next
programme can be
selected and started.
16
11:05 Page 16
OPTION
BUTTONS
Turning the machine On
Turn the machine ON by selecting a programme using the
programme selector. This status will be indicated by the STOP
indicator light flashing, this light will continue to flash until
the machine has started or the machine is returned to the OFF
position.
Start Pause
START
After selecting the programme and the required options press
the Start Pause button once to start the wash cycle. The STOP
light will stop flashing and START light will illuminate and
there will be a short time delay to the start of the programme
while the machine sets the wash parameters for the selected
programme and options. If the duration of the programme
you have selected is shorter than 60 minutes, then the time
remaining indicator will illuminate accordingly. The door lock
indicator light will also illuminate a few seconds after pressing
the Start Pause button.
PAUSE
The programme may be paused at any time during the wash
cycle by holding down the Start Pause button for about two
TEMPERATURE PROGRAMME
SELECTOR
SELECTOR