Copy Size - Konica Minolta Di5510 User Manual

Basic Operations

Copy Size

The tray selection keys below COPY SIZE are used to select a specific paper tray. When a
specific tray is selected, the APS key will fade and the AMS key will be highlighted. The
copy size may require a ratio adjustment. When using the EDH with Initial settings, a ratio
will be selected automatically.
Tray locations correspond to main body (tray 1, 2, 3, 4), LCC, and Multi-sheet bypass tray.
Paper types, such as Thick, Thin, User, Tab paper, Normal, Recycle, Color, Special, Fine,
Seal may be specified on the trays by the Key Operator for information only, but paper
types cannot be detected by the machine.
NOTE: Do not load paper type other than that specified, otherwise machine trouble may be caused.
❒ When a selected tray is empty, an out-of paper icon will flash on the tray key, along with a
message to load paper in the empty tray.
❒ When the Bypass key is touched and highlighted, the PAPER TYPE/SIZE key appears above the
Bypass key. Touch the key to display the Paper Type/Size popup menu, then specify the type and
size of the special paper to be loaded on the Multi-sheet bypass tray. See the next page.
❒ Incompatible Basic Copying Conditions with AMS: APS, Change magnification
❒ Incompatible Special Original with AMS: None
❒ Incompatible Applications with AMS: Book Copy, Non-Image Area Erase, Repeat, AUTO Layout,
Overlay, Overlay Memory
Basic Screen
1 Touch the desired tray key. APS will fade, and AMS will be highlighted.
When selecting the Bypass key, see p. 6-24 ~ p. 6-26.
To restore the APS mode, touch APS . AMS will fade, and APS will be highlighted.
2 Position original(s) FACE DOWN on the platen glass or FACE UP in the EDH, as
required.
3 When all settings are acceptable, press [ Start ] from the Basic Screen.
Basic Screen
6-23