Copy Size - Konica Minolta 3240 User Manual

Basic Operations
The Basic Screen (continued)

Copy Size

Copy Size is used to display the selection screen where you may reset the APS mode, or select a
specific paper tray. When a specific tray is selected, the copy size may require a ratio adjustment.
When using the RADF with automatic settings, a ratio will be selected automatically.
Tray locations correspond to trays 1, 2, 3, 4, 5 shown on p. 3-2.
When a selected tray is empty, an out-of-paper icon will flash on the Paper tray selection screen, along with
a message to load paper in the empty tray.
When a tray is empty, but not selected or in use, the out-of-paper icon will appear, but will not flash in the
message area.
If a tray size is changed by the service technician, the new paper size will be reflected on the screen,
automatically.
Incompatible with AMS: APS, Reduce & Shift, Change Magnification.
Basic screen
1 Press [F4 (APS)] to display the Paper tray selection screen.
2 Press [F1 (APS)]; or press [F3] to select a specific paper tray.
3 When the desired selection is highlighted, press [OK] to return to the Basic screen.
To cancel the setting, press [OK].
4 When all settings are acceptable, press [START PRINT] from the Basic screen.
Paper tray selection screen
Basic Operations 5-13