Konica Minolta 9760 User Manual page 44

02 MCF(MULTI-LOC.)
This function automatically prints a Message
Confirmation Report after each multiple-location
transmission. The report provides information about the
transmission. Refer to the "Reports, Message
Confirmation Report" section of this user's manual.
Available settings are ON (default) and OFF.
03 ERR REPORT (MCF)
This function automatically prints a Message
Confirmation Report every time an error occurs during a
transmission or polling transmission operation. The report
provides information about the transmission. Refer to the
"Reports, Message Confirmation Report" section of this
user's manual.
Available settings are ON (default) and OFF.
04 IMAGE IN MCF
When a message confirmation of a memory transmission is
printed, this function adds a portion of the first page of the
document that was sent. This feature makes it easier to
identify a fax, but it may present security problems if you
are sending sensitive documents.
Available settings are ON (default) and OFF.
|
44 KONICA FAX 9760
05 SENDER ID
This function controls the printing of your fax machine's
Sender ID on the faxes you send. Refer to the
"Programming Required Information, Fax Identification"
section of this user's manual for details. When turned on,
the Sender ID will be printed on each page slightly
outside the image area of your document. The default
setting is ON.
!
In order to meet FCC requirements, you must have this
feature set to ON and have a valid Sender ID
programmed in your fax machine.
06 MONITOR VOLUME
This function sets the volume for telephone line
monitoring during dialing.
Available settings are LOW (default), HIGH, and OFF.
07 BUZZER VOLUME
This function sets the volume of the various tones your
fax machine emits during operation. Available settings are
LOW, MIDDLE (default), and HIGH.