Payne PA1Z030 Installation, Start-Up And Service Instructions Manual page 3

COIL
V
2476
C9,7S]
L,
I
_2940 _4080
[II,5?]
[15,06]
£
356.B UIA,
REAR VIEW [14.ol
DUCTOPENINGS
J295.0
t_O,98J
BOTTONI 0T UNIT
f\ 1
\
\
t
812.5
131._9]
BOTTON OF UNIT
REQUIRED CLEARANCES TO COMBUSTIBLE MAT'L -- mm (in.)
Top of Unit ...................................... O
Duct Side of Unit .................................. O
Side Opposite Ducts ................................ 0
Bottom of Unit .................................... 0
NEC REQUIRED CLEARANCES -- mm (in.)
Between Units, Power Entry Side ............. 1066.8 (42.00)
Unit and Ungrounded Surfaces, Power
Entry Side ............................. 914.0 (36.00)
Unit and Block or Concrete Walls and Other
Grounded Surfaces, Power Entry Side ......... 1066.8 (42.09)
REQUIRED CLEARANCES FOR SERVICING -- mm (in.)
Condenser Coil Access Side ................. 762.0 (30.00)
Power Entry Side ......................... 762.0 (30.00)
(Except for NEC Requirements)
Unit Top ................................ 914.0 (36.00)
Side Opposite Ducts ....................... 762.0 (30.00)
LEGEND
NEC -- National Eiectrical Code
NOTES:
1. Clearances must be maintained to prevent recircuIation of air from
outdoor-fan discharge, with the exception of the condenser coil
(914 mm [36 in.]). A removable fence or barricade requires no
clearance.
2. Dimensions are in millimeters. Dimensions in ( ) are in inches.
LEFT SIDE VIEW
BLOWER, CONTROL BOX AND
EVAPORATORC01L ACCESS PANEL
COMPRESSOR PAH£
FI[L_ ZNTRY
SERVIC[ PORTS
FRONT VIEW
UNIT ELECTRICAL UNIT WT
PA1Z CHARACTERISTICS Ib kg
042 208/230-1-60, 208/230-3-60 297 135
048 208/230-1-60, 208/230-3-60 310 141
CENTER OF GRAVITY -- mm (in,)
X Y Z
355.6 (14.00) 508.0 (20.00) 304.8 (12.00)
355.6 (14.00) 508.0 (20.00) 304.8 (12.00)
Fig. 3 -- Base Unit Dimensions, PAIZ042,048
_R3.5
[2 S0}
--3--