Advertisement
MODEL PA10
10 SEER 3-PHASE AIR CONDITIONER
AVAILABLE SIZES:
Nominal sizes available (036, 048 and 060) to
meet the needs of light commercial applications.
CERTIFICATION:
All models are listed with UL, (U.S. and Can-
ada), ARI, and CEC.
ELECTRICAL RANGE: 208/230v, three phase in 036, 048 and 060
sizes; and 460v, three phase in 060 size.
FAN MOTOR:
The totally enclosed fan motor provides greater
reliability under adverse conditions and depend-
able performance for many years. The permanent
split capacitor type motor was designed for opti-
mum efficiency. The motor was then qualified
under extreme conditions to help ensure a long,
reliable life.
CABINET:
A weather protective cabinet of prepainted steel is
protected underneath by a galvanized coating and
treated with a layer of zinc phosphate for a finish
that will last for many years. All screws on cabinet
exterior are coated for a long-lasting, rust-
resistant, quality appearance.
UNIT DESIGN:
The copper tube, enhanced sine wave, aluminum
fin coil is designed for optimum heat transfer. Ver-
tical air discharge carries sound and hot con-
denser air up and away from adjacent patio areas
and foliage. The base pan is designed for easy
removal of water, dirt, and leaves.
Product Data
FEATURES
COMPRESSOR:
3-PHASE
(SCROLL
COMPRESSOR
UNITS) MONITOR
BOARD:
SERVICE VALVES:
SERVICEABILITY:
LIMITED
WARRANTY:
Each compressor is protected with internal tem-
perature- and current-sensitive overloads. An
internal pressure relief valve provides high-
pressure protection to the refrigerant system. For
improved serviceability, all models are equipped
with a compressor terminal plug.
Both service valves are brass, front seating type
with sweat connections. Valves are externally
located so refrigerant tube connections can be
made quickly and easily. Each valve has a service
port for ease of checking operating refrigerant
pressures.
Control board that monitors the electrical phase
and prevents compressor operation if wired
incorrectly.
One panel provides access to electrical controls.
Removal of top gives access to fan motor, com-
pressor, and condenser coil.
Standard 1-year limited warranty on parts and 5-
year limited warranty on compressor.
Advertisement
Table of Contents
Related Manuals for Payne PA10 Series
Summary of Contents for Payne PA10 Series
-
Page 1: Product Data
MODEL PA10 10 SEER 3-PHASE AIR CONDITIONER Product Data FEATURES AVAILABLE SIZES: Nominal sizes available (036, 048 and 060) to COMPRESSOR: Each compressor is protected with internal tem- meet the needs of light commercial applications. perature- and current-sensitive overloads. An... -
Page 2: Model Number Nomenclature
NOTE: Tested in accordance with ARI standard 270.95. (Not listed with ARI.) ISO 9001:2000 REGISTERED MODEL NUMBER NOMENCLATURE PA10 Variations Type of Unit Series PA10 – Electric Air Conditioner Variation Electrical Supply A — Standard Unit P — 208/230-3-60 E — 460-3 Heating Capacity Refrigerant–R22 Nominal Cooling Capacity 036 –... - Page 3 —3—...
-
Page 4: Metering Device
METERING DEVICE CHARGING SUBCOOLING (TXV-TYPE EXPANSION DEVICE*) PISTON* UNIT SIZE-SERIES IDENTIFICATION NO. REQUIRED SUBCOOLING UNIT SIZE (°F) 036-A 048-A 060-A * Piston listed is for any approved coil non-capillary tube combination. Piston is shipped with outdoor unit and must be installed in an approved indoor coil. SPECIFICATIONS UNIT SIZE SERIES... -
Page 5: Accessory Usage Guideline
ACCESSORY USAGE GUIDELINE REQUIRED FOR REQUIRED FOR REQUIRED FOR LOW-AMBIENT LONG-LINE SEA COAST APPLICATIONS APPLICATIONS* APPLICATIONS ACCESSORY (Below 55°F) (Over 80 Ft) (Within 2 Miles) Compressor Crankcase Heater Evaporator Freeze Thermostat Winter Start Control Yes† Accumulator MotorMaster® Control Wind Baffle See low-ambient instructions Support Feet Recommended... - Page 6 ACCESSORY DESCRIPTION AND USAGE (Listed Alphabetically) Continued 12. Thermostatic Expansion Valve (TXV) Kits A modulating flow control valve which meters refrigerant liquid flow rate into the evaporator in response to the superheat of the refrigerant gas leaving the evaporator. Kit includes valve, adapter tubes, and external equalizer tube. SUGGESTED USE: For improved system performance in cooling mode for certain combinations of indoor and outdoor units.
-
Page 7: Ratings And Performance
RATINGS AND PERFORMANCE SEER FACTORY PAYNE GAS SUPPLIED FURNACE OR UNIT INDOOR TOT. CAP. ENHANCE- STANDARD ACCESSORY ACCESSORY SIZE-SERIES MODEL BTUH MENT RATING TDR† TXV‡ *CC5A/CD5AA036 33,800 NONE 10.00 10.20 10.20 9.15 CAR**3614A** 33,200 — 10.00 — 9.05 CAR**3617A** 33,200 —... - Page 8 † In most cases, only 1 method should be used to achieve TDR function. Using more than 1 method in a system may cause degradation in performance. Use either the accessory Time-Delay Relay KAATD0101TDR or a furnace equipped with TDR. Most Payne furnaces are equipped with TDR.
-
Page 9: Detailed Cooling Capacities
DETAILED COOLING CAPACITIES* CONDENSER ENTERING AIR TEMPERATURES °F EVAPORATOR Capacity Capacity Capacity Capacity Capacity Total Total Total Total Total MBtuh† MBtuh† MBtuh† MBtuh† MBtuh† System System System System System Total Sens‡ kW** Total Sens‡ kW** Total Sens‡ kW** Total Sens‡ kW** Total Sens‡... - Page 10 DETAILED COOLING CAPACITIES* Continued CONDENSER ENTERING AIR TEMPERATURES °F EVAPORATOR Capacity Capacity Capacity Capacity Capacity Total Total Total Total Total MBtuh† MBtuh† MBtuh† MBtuh† MBtuh† System System System System System Total Sens‡ kW** Total Sens‡ kW** Total Sens‡ kW** Total Sens‡...
- Page 11 DETAILED COOLING CAPACITIES* Continued CONDENSER ENTERING AIR TEMPERATURES °F EVAPORATOR Capacity Capacity Capacity Capacity Capacity Total Total Total Total Total MBtuh† MBtuh† MBtuh† MBtuh† MBtuh† System System System System System Total Sens‡ kW** Total Sens‡ kW** Total Sens‡ kW** Total Sens‡...
-
Page 12: System Design
9. Use only copper wire for electric connection at unit. Aluminum and clad aluminum are not acceptable for the type of connector provided. © Payne Heating & Cooling Systems 7310 W. Morris St. Indianapolis, IN 46231 Printed in U.S.A.