D-Fi™ 2.4 Ghz (Dmx Mode Manual Sync) - Chauvet Freedom Par User Manual

D-Fi™ 2.4 Ghz
(DMX Mode
Manual Sync)
Page 20 of 76
The Freedom™ series offers wireless control of two or more products with a single DMX
controller. To manually set up the D-Fi™ syncing function for DMX functionality, do the
following:
For the transmitting product:
1. Press <MODE> repeatedly until SYS, ACt, SLAv, or S-1r shows on the display.
2. Use <UP> or <DOWN> to select SYS.
3. Press <ENTER>.
4. Press <UP> or <DOWN> until S-tr appears on the display.
5. Press <ENTER>.
6. Press <UP> or <DOWN> until dt.CH appears on the display.
7. Press <ENTER>.
8. Use <UP> or <DOWN> to select the transmitting signal (dt.01-dt.16).
For the receiving product(s):
1. Press <MODE> repeatedly until SYS, ACt, SLAv, or S-1r shows on the display.
2. Use <UP> or <DOWN> to select SYS.
3. Press <ENTER>.
4. Press <UP> or <DOWN> until S-tr appears on the display.
5. Press <ENTER>.
6. Press <UP> or <DOWN> until dR.CH appears on the display.
7. Press <ENTER>.
8. Use <UP> or <DOWN> to select the receiving signal (dr.01–dr.16). The channel
number should match the transmitting signal you chose in the prior steps.
Once the steps above are done, you can then back out to a more general menu level
and configure the transmitting product to operate it with a DMX controller.
To configure your product to work with DMX, refer to the
Operation section of this manual.
If you are experiencing antenna issues or need to improve signal quality, extend the
antenna outward away from the product and keep the line of sight between products
unobstructed.
Ensure that all linked products are configured to the same DMX personality (either
3-channel or 4-channel).
To sync multiple transmitters in one room, manually set each receiver and the
designated transmitter to a specific frequency and then perform the syncing steps.
The Freedom™ series is fully compatible with the D-Fi™ 2.4 GHz wireless transceiver
(transmitter/receiver) from CHAUVET ® (sold separately).
For more detailed information about D-Fi™ functionality, refer to the D-Fi™ 2.4 GHz
User Manual available at the CHAUVET ® website:
Starting Address section of the
www.chauvetlighting.com
Freedom™ series User Manual (Rev. 6 ML)