Aligning The Wall Plate - GE JVM2052 Installation Instructions Manual

Installation Instructions
| ALIGNING THE WALL PLATE
HoleC Centerline
Notches
0000000
0 0 0000000
!
AreaE
Drawa Vertical
Lineon Wall
_-_ from Centerof
TopCabinet
Hole B
A CAUTION:
Weor gloves
to avoid cutting fingers on sharp edges.
HoleD
[]
%
%
Draw a vertical line on the wall at the center of the
]0" wide space.
Use the mounting plate as the template for the rear
wall. Place the mounting plate on the wall, making
sure that the tabs are touching the bottom of the
cabinet or the level line drawn in Step C for cabinets
with front overhang. Line up the notch and centerline
on the bottom of the mounting plate to the centerline
on the wall.
While holding the mounting plate with one hand, draw
circles on the wall at holes A, B, C and D (seeillustration
above/actual plate marked with arrows). Four holes
must be used for mounting.
NOTE:Holes C and D are inside area E.If neither C nor D
is in a stud, find a stud somewhere in area E and draw
a fifth circle to line up with the stud. It is important to use
at least one wood screw mounted firmlg in o stud to
support the weight of the microwave oven.
Set the mounting plate aside.
A WAR NING: Risk ofElectric Shock. Can
cause injury or death. Take care to not drill into electrical
wiring inside walls or cabinets.
[] Drill holes on the circles. If there is a stud, drill a YS' hole
for wood screws. For holes that don't line up with a stud,
drill a %" hole for toggle bolts.
NOTE:DO NOTmount the plate at this time.
10