ALIGNING THE WALL PLATE
D.
Hole A
CAUTION: Wear gloves
to avoid cutting fingers on
sharp edges.
1
Draw a vertical line on the wall at the center of the
76.2 cm (30") wide space.
2
Use the mounting plate as the template for the rear
wall. Place the mounting plate on the wall, making sure
that the tabs are touching the bottom of the cabinet or
the level line drawn in Step C for cabinets with front
overhang. Line up the notch and centerline on the
bottom of the mounting plate to the centerline on the
wall.
3
While holding the mounting plate with one hand, draw
circles on the wall at holes A, B, C and D (see
illustration above/actual plate marked with arrows).
Four holes must be used for mounting.
Installation Instructions
Hole C
Centerline
Notches
Area E
10
Draw a Vertical
Line on Wall
from Center of
Top Cabinet
Hole D
NOTE: Holes C and D are inside area E. If neither C
nor D is in a stud, find a stud somewhere in area E and
draw a fifth circle to line up with the stud. It is
important to use at least one wood screw mounted
firmly in a stud to support the weight of the microwave.
Set the mounting plate aside.
Drill holes on the circles. If there is a stud, drill a
4
hole for wood screws. For holes that don't line up with
a stud, drill a
5
⁄
" hole for toggle bolts.
8
NOTE: DO NOT MOUNT THE PLATE AT THIS
TIME.
Hole B
"
3
⁄
16