GE JVM2052 Installation Instructions Manual page 17

Installation Instructions
J--_ ADAPT MICROWAVE OVEN
BLOWER FOR OUTSIDE BACK
EXHAUST (cont.)
[_ Carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust
the blower unit.
EndB
EndA
[_ Rotate the unit so that the exhaust ports face
the rear of the cabinet. When you insert the blower
unit, the blower wire must be as shown.
Blowerunit
Exhaust ports
[_ Place the blower unit back into the cabinet.
Check that the exhaust ports face toward
the rear of the cabinet.
WARNING: Risk ofelectric shock
can cause injury or death. Do not pull or stretch
the blower unit wiring. Make sure the wires
are not pinched.
NOTE:The blower unit exhaust openings should
match exhaust openings on rear of microwave oven.
[_ Reattach the blower plate to the cabinet so
the exhaust ports and blower plate opening
are aligned. Attach with 2 blower unit mounting
screws and then ] blower plate mounting screws.
Blowerunit
Blower p late
mounting screw
.__
(3 screws)
........
.............
wer
plate" !"" i
__'Blowe[ unit
_ _ - mounting screw
Blower u nitexhaust ports (2screws)
[_ Attach the exhaust adapter to the rear of the
oven by sliding it into the guides at the top
center of the back of the oven.
Adapter
Back of
Microwave O ven
"_ Locking T abs
Guide
Guide
Push in securely until it is in the lower locking
tabs. Take care to ensure that the damper hinge
is installed so that it is at the top and that the
damper swings freely.
17