Preparation Of Top Cabinet - GE JVM2052 Installation Instructions Manual

Installation Instructions
IC-1RECIRCULATING
(Non-Vented Ductless)
INSTALLATION OVERVIEW
C1. Attach Mounting Plate to Wall
C2. Prepare Top Cabinet
C3. Adjust Blower
C4. Mount the Microwave Oven
C5. Install Charcoal Filter
|
i
ATTACH THE MOUNTING PLATE
TO TH E WALL
\
Attach the plate to the wall using toggle bolts.
At least one wood screw must be used to attach
the plate to a wall stud.
[] Remove the toggle wings from the bolts.
[_ Insert the bolts into the mounting plate through
the holes designated to go into drywall and
reattach the toggle wings to s/4"onto each bolt.
To use toggle bolts:
Spacingfor Toggles
MoreThanWall
-,-J._,-i.,_Th ickness
ToggleWings
Mounting
Plate
Bolt End
[_ Place the mounting plate against the wall and insert
the toggle wings into the holes in the wall to mount
the plate.
NOTE: Before tightening toggle bolts and wood screw,
make sure the tabs on the mounting plate touch
the bottom of the cabinet when pushed flush against
the wall and that the plate is properly centered under
the cabinet.
.4,CAUTION:
Be careful to avoid pinching
fingers between the back of the mounting plate and
the wall.
[_ Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts.
USE TOP CABINET TEMPLATE FOR
PREPARATION OF TOP CABINET
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.
• Read the instructions on the TOPCABINETTEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the TOP
CABINETTEMPLATE.
CAUTION: Wear safety goggles w,en
drilling holes in the cabinet bottom.
19