Preparation Of Top Cabinet; Adapt Microwave Oven Blower - GE JVM2052 Installation Instructions Manual

Installation Instructions
[-_ ATTACH THE MOUNTING PLATE
TO THE WALL
!
Attach the plate to the wall using toggle bolts.
At least one wood screw must be used to attach
the plate to a wall stud.
[] Remove the toggle wings from the bolts.
I_ Insert the bolts into the mounting plate through
the holes designated to go into drywall and reattach
the toggle wings to 3/a"onto each bolt.
To use toggle bolts:
Spacing f orToggles M ore
--I-_--!-,_- Than WallThickness
M .. IToggleWings
oummg II1'._1i I ToggleII 1'..1
P ate lll:l Bolt II I::K
III ':t_--Wall II lql I
BoltEnd
[_ Place the mounting plate against the wall and insert
the toggle wings into the holes in the wall to mount
the plate.
NOTE: Before tightening toggle bolts and wood screw,
make sure the tabs on the mounting plate touch
the bottom of the cabinet when pushed flush against
the wall and that the plate is properlg centered under
the cabinet.
-A CAUTION:
Be careful to avoid pinching
fingers between the back of the mounting plate and
the wall.
[_ Tighten all bolts. Pull the plate awag from the wall
to help tighten the bolts.
USE TOP CABINET TEMPLATE FOR
PREPARATION OF TOP CABINET
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.
• Read the instructions on the TOP CABINETTEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the TOP
CABINETTEMPLATE.
-A CAUTION:
Wear safetg goggles when
drilling holes in the cabinet bottom.
[--_ ADAPT MICROWAVE OVEN
BLOWER FOR OUTSIDE BACK
EXHAUST
[] Remove and save 3 blower plate mounting screws
and 2 blower unit mounting screws.
Blowerunit
Blowerplate
mountingscrew
.__ (3 screws)
_ Blowerplate
__ Backplate
3lower unit
-_d_---------- mountingscrew
(2 screws)
Use side cutters or tin snips to cut and remove
knockouts from back plate. Discard the knockouts.
Be careful not to distort the plate.
16