Aligning The Wall Plate - GE JVM1660CB002 Installation Instructions Manual

Installation Instructions
ALIGNING THE WALL PLATE
|
i
HoleC Centerline
Notches
OO 0 9 0 OC OO ONO
ooooco0o oc 0080
CAUTION: Wear gloves
to avoid cutting fingers on
sharp edges.
[1 | Draw a vertical line on the wall at the center of the
30" wide space.
[2 | Use the mounting plate as the template for the rear
wall. Place the mounting plate on the wall, making
sure that the tabs are touching the bottom of the
cabinet or the level line drawn in Step C for cabinets
with front overhang. Line up the notch and centerline
on the bottom of the mounting plate to the centerline
on the wall.
While holding the mounting plate with one hand,
draw circles on the wall at holes A, B, C and D
(see illustration above /actual plate marked with
arrows). Four holes must be used for mounting.
~— from Center of
eo0oO06UdUcOCCcOUCUOCOUD
=
Hole B
Draw a Vertical
Line on Wall
Top Cabinet
OOo OO OO O00 0
Hole D
NOTE: Holes C and D are inside area E. If neither
C nor D is in a stud, find a stud somewhere in area E
and draw a fifth circle to line up with the stud. It is
important to use at least one wood screw mounted
firmly in a stud to support the weight of the microwave.
Set the mounting plate aside.
Drill holes on the circles. If there is a stud, drill a "6"
hole for wood screws. For holes that don't line up with
a stud, drill a %" hole for toggle bolts.
NOTE: DO NOT MOUNT THE PLATE AT THIS
TIME.
10