Safety Rules - Briggs & Stratton 01931-0 Installation And Start-Up Manual

10.000 rated watts home generator
Hide thumbs Also See for 01931-0:
Table of Contents

Advertisement

Available languages

Available languages

I:_;1_-_:_Je_-'l
Briggs & Stratton Power ProductsHome Generator
Installation
Manual
SAFETY
RULES
The safety alert symbol (_IL) is used with a signal word
(DANGER,
CAUTION,WARNING),
a pictorial and/or a
safety message to alert you to hazards. DANGER
indicates
a hazard which, if not avoided, will result in death or serious
injury. WARNING
indicates a hazard which, if not avoided,
could result in death or serious injury. CAUTION
indicates a hazard which, if not avoided, might result in
minor or moderate
injury. CAUTION,
when used
without
the alert symbol, indicates a situation that could
result in equipment
damage. Follow safety messages to
avoid or reduce the risk of injury or death.
WARNING
• DO NOT handle generator
or electrical
cords while standing
in water, while barefoot, or while hands or feet are wet.
• If you must work around a unit while it is operating,
stand on
an insulated dry surface to reduce shock hazard.
• DO NOT allow unqualified
persons or children
to operate or
service generator.
• In case of an accident caused by electrical
shock, immediately
shut down the source of electrical
power and contact the
local authorities.
Avoid
direct
contact
with the victim.
• Before performing
any maintenance
on the generator,
disconnect
the battery
cable indicated by a NEGATIVE,
NEG or (-) first.When
finished, reconnect
that cable last.
• After your Home Standby Generator
is installed, the
generator
may crank and start without
warning
any time there
is a power failure.To
prevent
possible injury, always set the
AUTO/OFF/MANUAL
switch to OFF AND
remove the
15 Amp fuse BEFORE
working
on the equipment.
WARNING
Only
qualified
electricians
and
gaseous
fuel
technicians
should
attempt
installation
of this
system,
which
must
strictly
comply
with
applicable
codes,
standards
and
regulations.
WARNING
Install the fuel supply system according
to applicable fuel-gas
codes.
Before placing the Home Standby Generator
into service, the
fuel system lines must be properly
purged and leak tested.
After the system is installed, you should inspect the fuel
system periodically.
NO leakage is permitted.
I
CAUTION
DO NOT tamper with engine governed
speed.
CAUTION
Adequate, unobstructed
flow of cooling and ventilating
air is
critical to correct
generator
operation.
Keep at least 3 feet of clearance on all sides of generator
for
adequate ventilation.
Despite the safe design of the Home Standby Generator,
operating this equipment imprudently, neglecting its maintenance
or being careless can cause possible injury or death.
Remain alert at all times while working
on this equipment.
NEVER work on the equipment
when you are physically or
mentally fatigued.
DO NOT use the generator
or any of its parts as a step.
Stepping on the unit can cause stress and break parts.This
may result in dangerous
operating
conditions
from leaking
exhaust gases, fuel leakage, oil leakage, and so forth.
3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents