Table of Contents
Advertisement
5. Fit the memory module's connectors into the socket at about a 45
degree angle and push the module down until latches on either side
snap into place.
■
Be careful not to drop the screw inside the computer.
■
Do not touch the connectors on the memory module or on the
computer. Debris on the connectors may cause memory access
problems.
6. Seat the memory module cover and secure it with one screw.
7. Install the battery pack. Refer to
Chapter 6, Power, for details.
8. Turn the power on and make sure the added memory is recognized.
Open System Properties in the Control Panel and click the General
tab.
Removing memory module
To remove the memory module, make sure the computer is in boot mode
then:
1. Turn off the power and disconnect all cables from the computer.
2. Turn the computer upside down and remove the battery.
3. Loosen one screw securing the memory module cover and lift off the
cover. Refer to figure 8-5.
4. Push the latches to the outside to release the module. A spring will
force one end of the module up.
5. Grasp the module by the sides and pull it out.
■
If you use the computer for a long time, the memory modules and the
circuits located close to the memory modules will become hot. In this
case, let them cool to room temperature before you replace them.
■
Do not touch the connectors on the memory module or on the
computer. Debris on the connectors may cause memory access
problems.
User's Manual
Figure 8-6 Seating the memory module
Replacing the battery pack
Optional Devices
section in
8-7
Advertisement
Table of Contents
