Table of Contents
Advertisement
Built-in LAN disabled
Under certain conditions, LAN will automatically be moved to the last item in
the boot priority list.
If you disable Built-in LAN in HW Setup, LAN will become the last item the
next time you start the computer. For example:
1. Boot priority option is set to HDD -> LAN -> FDD -> CD-ROM.
2. You disable Built-in LAN in HW Setup and restart the computer.
3. The boot priority option setting will automatically change to HDD -> FDD
-> CD-ROM -> LAN.
If you enable Built-in LAN and change the boot priority setting, LAN will
remain in the last position the next time you start the computer. Your
selected boot priority will become effective from the second time you start
the computer.
■
If a supervisor password is set, the menu above does not appear when
you use the user password to start the computer.
■
The selection method above does not change the boot priority settings
in HW Setup.
■
If you press a key other than one of those above or if the selected
device is not installed, the system will boot according to the current
setting in HW Setup.
■
Support of PC (ATA) card boot is guaranteed only for TOSHIBA PC
card HDDs.
■
A PC (ATA) card takes the position of HDD in the Boot Priority Options
list.
Network Boot Protocol
This feature sets the protocol to remotely boot from the network.
Keyboard
Wake-up on Keyboard
When this feature is enabled and the computer is in Standby mode, you
can turn on the computer by pressing any key. It is effective only for the
internal keyboard and only when the computer is in standby mode.
Enabled
Disabled
User's Manual
[PXE] Sets PXE as the protocol. (Default)
[RPL] Sets RPL as the protocol.
Enables the Wake-up on Keyboard.
Disables the Wake-up on Keyboard. (Default)
HW Setup
7-3
Advertisement
Table of Contents
