Table of Contents
Advertisement
3. Lay the CD/DVD, label side up, in the drawer.
When the drawer is fully opened, the edge of the computer will extend
slightly over the CD/DVD tray. Therefore, you will need to turn the CD/DVD
at an angle when you place it in the tray. After seating the CD/DVD,
however, make sure it lies flat, as shown in figure 4-6.
■
Do not touch the laser lens. Doing so could cause misalignment.
■
Do not keep foreign matter from entering the drive. Check the back
edge of the tray to make sure it carries no debris before closing the
drive.
4. Press gently at the center of the CD/DVD until you feel it click into
place. The CD/DVD should lie below the top of the spindle, flush with
the spindle base.
5. Push the center of the drawer to close it. Press gently until it locks into
place.
If the CD/DVD is not seated properly when the drawer is closed, the CD/
DVD might be damaged. Also, the drawer might not open fully when you
press the eject button.
User's Manual
Figure 4-6 Inserting a CD/DVD
Figure 4-7 Closing the CD/DVD drawer
Operating Basics
4-5
Advertisement
Table of Contents
