Assembly - Star Trac Instinct Owner's Manual

W B I R
EIGHT ELT NSPECTION EQUIREMENTS
WARNING: REPLACE WORN WEIGHT BELTS IMMEDIATELY. FAILURE TO COMPLY CAN RESULT IN HAZ-
ARDOUS CONDITIONS FOR USERS OR OTHER BYSTANDERS.
Inspect all weight belts for evidence of excessive wear or other damage. Give particular attention to the following conditions:
14
Torn or cracked belt
Exposed belt cords
Worn edges
STAR TRAC INSTINCT GLUTE PRESS O '
WNER S

ASSEMBLY

1. Assemble the Main Frame to the
Weight Frame
Align the two drilled holes in the lower cross-
beam (4) with the mating holes in the bottom of
the weight frame (1). Secure the crossbeam to
the weight frame using two screws (46), four
washers (49), and two lock nuts (48). Tighten the
nuts securely.
Align the two drilled holes in the upper cross-
beam (3) with the mating holes in the side beam
of the weight frame (1). Secure the crossbeam to
the weight frame using two screws (46), four
washers (49), and two lock nuts (48). Tighten the
nuts securely.
Position the main frame (2) so the two drilled
holes in the lower crossbeam (4) and the two
drilled holes in the upper crossbeam (3) are
aligned with the mating holes in the main frame.
Secure the main frame to the lower crossbeam
using two screws (46), four washers (49), and two
lock nuts (48). Tighten the nuts securely.
Secure the main frame to the upper crossbeam
using two screws (46), four washers (49), and two
lock nuts (48). Tighten the nuts securely.
2. Assemble the Weight Stack
NOTE: Two people are required to assemble the
weight stack; one to hold the weight stack guide
posts in position, and one to assemble the weight
stack components onto the posts.
Slide one weight stack support (33) onto each
weight stack guide post (19).
Insert the weight stack guide posts (19) into the
retaining holes in the base of the weight stack
frame (1). BE SURE the drilled ends of the
weight stack guide posts face upwards, toward
the top of the weight stack frame.
WARNING: TO PREVENT INJURY, IN-
STALL THE WEIGHTS ONE AT A TIME.
Install weights (24, 25, 26) on the weight stack
guide posts (19), one at a time, in the following
sequence:
Weight, 15lb (26) - three required
Weight, 10lb (26) - three required
Weight, 5lb (26) - three required
Slide the looped end of the lanyard on the selector
pin (27) onto the shaft of the top plate (22).
NOTE: BE SURE to hold the lanyard in place
when installing the top plate.
Install the top plate (22) on the weight stack guide posts (19), inserting the top plate shaft through the holes in the
weights. Insert the selector pin (27) through one weight until it engages the top plate shaft.
Install one rubber cap (28) onto each weight stack guide post (19).
M STAR TRAC INSTINCT GLUTE PRESS O
ANUAL
3 48 49
48
49
48
49
46
48
49
48
49
46
49
46
49
46
2
20
17
41
20
17
' M
WNER S ANUAL
49 46
1
46
49 46
49
46
49
49
48
4
48
49
42
49
42
28 49
28
19
41
22
24
25
26
27
33
33
7