Jenn-Air JDRP436WP01 Installation Instructions Manual page 14

5,
Pull up on the control console and let it drop forward into the
notched console brackets on each side.
15. Lift up on the control console and set it back into place. For a
proper fit, the flange of the control console must hook over
the lip on the front of the range cooktop.
6,
7.
A. Control console bracket
Remove the round gasket from the valve stem.
Put a control knob onto the valve stem of the burner you want
to adjust.
..._J_- 77--- . ..........................
B
A. Control console flange
B. Front lip of range cooktop
16. Check that the control console is flush with the top edge of
the range.
8,
Turn the control knob to LO and using a butane extension
lighter, light the burner.
9. Remove the control knob.
10. Use a 1/8"x 4W' flat-blade screwdriver to adjust the flame
height. Tighten screw to reduce flame height. Loosen screw
to increase flame height.
NOTE: When you are converting to LP gas, the screw should
be tightened down completely.
\ ,,. ,..
i i
/
i
f
A
\
/
/
/
B
A. Single flame burner adjustment screw (on right side of valve)
B, Dual flame burner adjustment screw (on left side of valve)
11. When finished adjusting the flame height, put a control knob
back onto the valve stem and turn off the burner.
12. Remove the control knob.
13. Replace the round gasket.
14. Repeat steps 6 through 13 for any other burners that need
adjustment.
A, Flush with range top
17. Replace the 2 screws on each side of the control console.
18. Replace the control knobs.
19. Replace burner grates.
20. Test the flame by turning the control from LO to HI, checking
the flame at each setting.
Re 5<ck P ::x'Ns
1. Align shoulder screw mounting holes with shoulder screws on
range.
2. Push kick plate down against front of range until the top
screw holes are aligned with the mounting holes on the front
of the range.
3. Reattach screws to the top of the kick plate.
C
A. Kick plate
B, Reattach these screws.
C, Top screw hole
D, Shoulder screw mounting hole
14