Proper Use Of The Printer - Variquest Poster Maker 3600 User Manual

Proper use of the printer

When installing paper, pull the end of the roll out so
that any slack is removed from the paper. Align the
paper with the guide marks on both the left and right. If
the paper is not inserted properly, the poster may print
at an angle or the paper may wrinkle.
Guide mark
Before printing, verify that the printer cover is
properly closed by pushing down on BOTH SIDES
until it locks into place. If both sides of the cover are not
closed, only part of your poster will print.
Press
Avoid pressing down on the printer or scanner cover
while the printer is in operation.
Printing tip
It is best to turn the printer off before opening the cover to install paper. If you leave the printer on and then
install paper and close the cover, the printer will automatically advance the paper roll by approximately 1.8"
(45 mm), resulting in wasted paper. This does not occur if you turn the printer off before installing paper.
VariQuest™ Poster Maker 3600
the cover.
Power
switch
Guide mark
initializing or printing. Be sure the Ready indicator on
the control panel is lit before turning the power off.
printing. Doing so may affect the quality of the poster.
Press
the right side of the printer. If the cutter stops operating
due to an error and you need to move it to the right
manually, hold the cutter from the bottom (as shown
below) and move it towards the right until it stops. Do
not hold the top section; this may damage the cutter.
operation. This may cause a paper or cutter jam.
Turn off the printer's power switch before opening
Do not turn the power off while the printer is
Do not pull the paper out of the printer during
Before printing, be sure the cutter is positioned on
Push
here.
Do not lift the paper upward during the cutting
Getting Started
Do NOT
touch here.
1-7