Paper Axis Calibration - Kodak 217857-1 Reference Manual

2 Choose Utility Menu/Color Calib/C - Vert. Press Select.
3 Examine the Vertical Head-to-Head Test Pattern and choose the number that
represents the best color alignment for cyan-vertical.
4 Repeat for each color and for horizontal alignment as well, using the Horizontal
Head-to-Head Test Pattern.

Paper axis calibration

The Paper Axis Test prints a set of vertical marks to calibrate the paper axis. To measure
the marks laid down by the printer, you will need a ruler or scale at least 33 inches
(838.2 mm) long. The vertical marks should be exactly 33.00 inches (838.2 mm) apart. If
the distance between the marks is different from that shown on the display, you may
adjust the printer by setting its values to match the length or width you measured.
Note: The Paper Axis Test should be performed every time new media is loaded.
➪ ➪ ➪ ➪ ➪
To print the Paper Axis calibration test pattern
1 Load the printer with media that is at least 36 (91 cm) inches long (or the media that
you are going to run; you cannot load a 36" sheet and then run the calibration from
a roll feed because the line lengths will not match).
2 Choose Utility Menu/Paper Calib/Paper Axis Test. Press Select.
The printer prints two marks.
3 Remove the media from the printer and measure the distance between the marks.
The distance between the marks should be exactly 33.00 inches (838.2 mm).
4 If the measurement is not exactly 33.00 inches, select Paper Axis.
5 Press Select.
6 Press the up or down arrow button to adjust the value to the measurement read on
the scale and press Select.
ENCAD T-200 Reference Guide
® TM
Printer Setup 1-16