Sync Fast/Slow Adjustment; Peaking; Clamp Tuning - Runco DTV-1101 Owner's Operating Manual

Sync Fast/Slow Adjustment

The sync function is used to minimize horizontal jittering or tearing at
the top to the displayed image. Highlight SYNC by pushing the control
disk up or down and press ENTER to toggle between FAST and
SLOW .
Note: SYNC is normally used in the SLOW position.
ENTER will toggle Sync between FAST and SLOW
EXIT will return to the Random Access Adjustment Menu

Peaking

Peaking improves the contours in an projected image. Highlight
PEAKING by pushing the control disk up or down and press ENTER
to display the Peaking Menu.
During the creation of new settings for a RGB source, the correspond-
ing peaking is switched on as default. For frequencies between :
15 kHz — 45 kHz: Low frequency peaking
45 kHz — 85 kHz: Mid frequency peaking
85 kHz — 135 kHz: High frequency peaking
If another peaking is desired, use the control disk to highlight 'low',
'mid', or 'high' frequency or to switch off the peaking.

Clamp Tuning

Highlight CLAMP TUNING by pushing the control disk up or down and
press ENTER to toggle between NORMAL and RESTORATION.
Select Normal: - for all standard sources and all sources with a
backporch > 0.8 s
- for sources with noise and spikes in the signal
Select Restoration:
- for standard sources with a backporch between
0.4 s and 0.8 s
- for sources with sync separate or sync on Green
Random Access Adjustment Mode
PICTURE TUNING
COLOR BALANCE
SYNC : FAST
PEAKING
CLAMP TUNING : normal
Select with or
<ENTER> to accept
<EXIT> to return
PICTURE TUNING
COLOR BALANCE
SYNC : FAST
PEAKING
CLAMP TUNING : normal
Select with or
<ENTER> to accept
<EXIT> to return. PEAKING
OFF
LOW FREQUENCY
MID FREQUENCY
HIGH FREQUENCY
Select with or
then <ENTER>
<EXIT> to return
PICTURE TUNING
COLOR BALANCE
SYNC : FAST
PEAKING
CLAMP TUNING: normal
Select with or
<ENTER> to accept
<EXIT> to return
6-5