Connecting A Rgb Analog Source To Port 3 - Runco DTV-1101 Owner's Operating Manual

Connecting a RGB Analog Source to Port 3

Connect your RGB source via an interface to Port 3. Always
use an interface when a computer and local monitor have to be
connected to the projector.
RGB analog input with automatic sync detection. (Separate H
and V sync inputs, with composite sync input or with sync
signals on green)
Pin configuration D9 connector of the Analog input:
1 not connected
2 ground RGBS
3 RED
4 GREEN
5 BLUE
6 ground RGBS
7 ground RGBS
8 Hor/comp. sync
9 Vert. sync
Connecting a RGB or Component Source to Port 4/5
RGB analog input terminals with separate H and V sync inputs,
with composite sync input or with sync signals on green
(automatic sync detection), or component (Y, Pb, Pr) sources
from a DTV Decoder, etc.
PORT 4/5
( RGB + HV)
Comp/H sync V sync
. .
PORT 6
PORT 3
REMOTE
COMMUNICATION
. . .
R G
ANALOG INTERF. 120MHz
ON
. . INPUT
. .
B H
V
OFF
. . . . .
G
R
INP
75 Ohm ter m
PORT 4/5
( RGB + HV)
Comp/H sync V sync
. .
PORT 6
PORT 3
REMOTE
COMMUNICATION
. . .
R G
Connections
PROJECTOR MODE
GREEN: operational
RED: stand-by
B
.
INP
inver.
PROJECTOR MODE
GREEN: operational
RED: stand-by
B
3-3