Storage; Maintenance - Stamina Folding Cycle Owner's Manual

STORAGE

1. To store the inStride® Folding Cycle, simply keep it in a clean dry place.
2. The minimum folded dimensions of the inStride® Folding Cycle are approximately 15.5" long x 15"
wide x 6.5" tall. Please measure your inStride® Folding Cycle if exact dimensions are needed.
3. To move the inStride® Folding Cycle, lift the unit by the upright of the MAIN FRAME(1).
Caution: Make sure that the hub on the MAIN FRAME(1) has cooled before moving.
4. To fold, refer to illustration A, remove the LOCKING KNOB(20), and fold the FRONT FRAME(2) to
the MAIN FRAME(1). Reattach the LOCKING KNOB(20) to the FRONT FRAME(2). The inStride®
Folding Cycle should appear as shown in illustration B after folded.
A.

MAINTENANCE

The safety and integrity designed into the inStride® Folding Cycle can only be maintained when the
inStride® Folding Cycle is regularly examined for damage and wear. Special attention should be given
to the following:
1. Adjust the T KNOB(14) and verify that it functions properly and the resistance changes.
2. Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts.
Tighten loose nuts and bolts.
3. Verify that the CAUTION LABEL(27) is in place and easy to read. Call Stamina Products immediately
at 1-800-375-7520 for a replacement CAUTION LABEL(27) if it is missing or damaged.
4. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
5. Worn or damaged components shall be replaced immediately or the inStride® Folding Cycle
removed from service until repair is made.
6. Only Stamina Products supplied components shall be used to maintain/repair the inStride® Folding
Cycle.
7. Keep your inStride® Folding Cycle clean by wiping it off with an absorbent cloth after use.
9
B.