Storage; Maintenance - Stamina wirk Ride 85-2221C Owner's Manual

STORAGE

1. Remove all items from the DESKTOP(21) before moving or folding the Wirk
2. To store the Wirk
3. To avoid damage to the electronics, remove the batteries before storing the Wirk
for one year or more.
4. To move the Wirk
onto the WHEELS(32) of the REAR STABILIZER(10).
5. The minimum folded dimensions of the Wirk
long x 21.7 inches wide x 40.4 inches tall. Please measure your Wirk
dimensions are needed.
a. Use the LEVER(55) to adjust the UPRIGHT(3) backward to Position 5.
b. Remove the BALL PIN(49) from the REAR FRAME(2). Fold the REAR FRAME(2) close to the MAIN
FRAME(1) and lock it in folded position with the BALL PIN(49). Fold the BACK CUSHION(40) flat.
NOTE: Make sure the BALL PIN(49) goes through the holes on both sides of the REAR FRAME(2)
and the tube on the MAIN FRAME(1).
A

MAINTENANCE

The safety and integrity designed into the Wirk
TM
Wirk Ride Workstation is regularly examined for damage and wear. Special attention should be given
to the following:
1. Adjust the TENSION KNOB(57) and verify that it functions properly and the resistance changes.
2. Use a wrench to verify that the pedals are tightened securely. If tightening is required, remember that
the left pedal has left hand threads and is tightened by turning counterclockwise.
3. Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts.
Tighten loose nuts and bolts.
4. Verify that the CAUTION LABEL(103) is in place and easy to read. Call Stamina Products
immediately at 1-800-375-7520 for a replacement CAUTION LABEL(103) if it is missing or damaged.
5. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
6. Worn or damaged components must be replaced immediately or the Wirk
removed from service until repair is made.
7. Only Stamina Products supplied components should be used to maintain/repair the Wirk
Workstation.
TM
8. Keep your Wirk
TM Ride Workstation, simply keep it in a clean dry place.
TM
Ride Workstation, hold the HANDRAIL(8) and tilt the Wirk
Ride Workstation clean by wiping it off with an absorbent cloth after use.
TM
Ride Workstation are approximately 31.8 inches
TM
Ride Workstation can only be maintained when the
17
TM
Ride Workstation.
TM
Ride Workstation
TM
Ride Workstation
TM
Ride Workstation if exact
TM
Ride Workstation
B
TM Ride