Top To Rear Vent Modification - Lopi Northfield GS Owner's Manual

10

Top to Rear Vent Modification

NOTE: If using the rear vent configuration, make sure to review vent
configuration before proceeding.
Remove the cast iron stove top and flue cover to access the vent components (see page 29)
Remove the outer flue
assembly, cover plate, and
gaskets. Place the screws
and components aside (for
all subsequent steps).
Remove the inner flue
assembly and exhaust cover
plate.
ADJUSTING THE DIFFUSER ON THE INNER FLUE ASSEMBLY
Rear vent configurations with no rise require the
diffuser to be bent to the # 2 position. It is easiest
to adjust this component with the inner flue
removed. See the directions below.
Bottom of inner
flue assembly
© Travis Industries
Installation
a
Remove the
diffuser.
(for qualified installers only)
NOTE: Use a magnetic-tipped
nutdriver on these screws - take
care to prevent the screws from
falling into the intake channel.
Inner Flue
Assembly
Exhaust Cover Plate
b
Bend the round portion of the
diffuser so it is bent (position # 2).
DIFFUSER SIDE VIEW
Before (Stock - Position # 1)
After (Position # 2)
4091120
c
Replace the
diffuser.
100-01239_000