Chapter 2 Getting Started; Turning On The System; About The Lcd Panel Display; For Best Performance - Talon Pro User Manual

Talon CD Duplicator
Chapter 2 Getting Started

Turning on the System

Plug the AC cord into the Talon Pro system and then into a wall outlet. Press the ON/OFF button
located in the bottom right corner of the tower unit. The LCD Panel display will light up,
indicator lights on each of the CD writer drives will flash momentarily, the ON indicator light
next to the ON/OFF button will be lit, and the system will indicate it is ready for operation by
emitting a three-tone beep.

About the LCD Panel Display

When you first turn the system on, the information displayed in the LCD Panel will indicate the
current Status of operation (e.g. copy, emulate, etc.)
copy
<Statu
s
If copy is not displayed in the LCD Panel Display, press the Status button to cycle through the
list of operation Statuss (copy, copy+comp, emulate, compare, verify, external) until
copy is displayed. This will ensure that you are in the correct Status for the first exercise
presented in this manual, which is copying a CD to a CD (refer to page 3).

For Best Performance

All master CDs must be 52X quality. Use Talon Branded Bulk Media (CDs recommended for
best performance), which are available in 300-disc cartons.
Please consult the dealer where you purchased your unit for the recommended media.
A553M62:57
3