Talon Pro User Manual page 14

Make Multiple Copies at Once from a Master CD (continued)
Place Blank
CDs in the
Drives
Copy
Operation
Starts
Automatically
Remove the
Master CD
Note the
Initial
Operation
Status
Access the
Sub-Function
Menu
10
1. Place a blank CD in each of the CD writers. Note that the system starts
counting the number of active CD drives as you insert blank CDs.
Once the system has identified all of the blank CDs it automatically starts to
copy the contents from the selected partition on the hard drive to the blank
CDs. You can note the progress of the copy operation by observing the L
and C status. The copy operation is complete when the number for C equals
the number of minutes of the CD.
When the load procedure is finished, you will hear a three-tone beep, all
seven drawers will automatically open, and the LCD panel will indicate that
the load operation passed:
PASS 7 FAIL 0
11. Remove the duplicates from the drawers, close the drawers (using the
open/close button on the CD drive).
Congratulations! You have just made seven duplicates from the hard drive.
1. Turn on the system. Note the Status of operation in the LCD display
area (copy, emulate, etc.). Your LCD display should look something
like this:
copy
<Statu
s
2. Press and hold the Status button until you hear the system "chirp." Then
release the Status button. You should see setup displayed in the LCD
panel:
setup
<Statu
s
Talon CD Duplicator
Start>